NEW Katana Clean Boost – RKFX.com Exclusive Arlon Prince NOS Hand-swirled Custom Shop Edition!
This custom run will begin shipping on or before 01-18-2022.
Blast from the past & Custom to the core.
We premiered the hand-swirled Arlon Prince Katana Clean Boost back in 2014. In our facility move of mid-2021, we ran across a box of new old stock cases, and decided to offer them up again with our NEW Katana circuit placed inside. The best part? This time around you can pick your finish! There are only 11 available and no two are exactly alike. Grab your favorite today!
Note: These NOS cases are all completely unique and because of age may show slight imperfections. These Katanas are covered by our same great 2-year warranty!
WE ARE PROUD TO OFFER YOU THE BEST KATANA EVER.
The ALL NEW – KATANA CLEAN BOOST!
Our Katana Clean Boost is back and better than ever! Redesigned while going back to our roots.
We listened to what our players wanted and went back to our roots. The new Katana uses the original JFETs that made the original so special. We used the same component values from the original Katana, and updated the Boost mode to offer a more robust, clear sound, giving more clarity to bass notes when engaged. We updated the build with modern construction techniques to make this Katana the most dependable Clean Boost on the market, including an updated aluminium control knob, designed to be adjusted on the fly.
WANT A MIRROR IMAGE OF YOUR TONE, ONLY LOUDER? Roll the volume knob forward with your foot and you’ll be good to go! NEED EVEN MORE? The Katana Boost is also a fat, harmonically rich boost, just pull out on the volume knob and push the limits with overdriven tone! You can keep it on all the time to push your amp harder, or as an occasional boost to cut through the mix.
The Katana circuit is Robert Keeley’s first guitar effect design for Keeley Electronics. It was originally designed as part of the Time Machine Boost, but then became an independent product under the Keeley name after the release of the original Keeley Compressor.
Two modes, Pure Clean and High Gain
1. With the speed knob Pushed In, think of it as a volume control that goes to 20.
2. With the speed knob Pulled Out, it’s a cutting boost with a bit of gain. Not quite an overdrive, just overdriven tube grit and edge to your tone.
Dual FETs for the most tube like tone in a transistor design. Power Doubling on the inside so you put 9VDC in, and we use a charge pump to nearly double operating voltage! (Caution – 9 Volt DC Maximum Input Voltage (don’t try to put 18 volts to the unit hoping that the doubler will make it 36VDC!)
What do higher power supply voltage rails mean?! -> SUPER CLEAN HIGH-HEADROOM BOOST! Pull the Level knob out to switch -> Tube-like gain! THE EDGE!!!!